Zebra S400 User's Guide download pdf (Page 74)

Configuration

Control Panel Parameters

79695L-001 Rev. A ZM400/ZM600 User Guide 3/27/07

Set Print Width

This parameter specifies the printable area across the width of the label.

Table 13 shows the ranges and default values for print width, which are

based on the printer model and the printhead resolution.

Note • Setting the width too narrow can result in portions of a label

format not being printed on the media. Setting the width too wide

wastes formatting memory and can cause printing off of the label

and on the platen roller. This setting can affect the horizontal

position of the label format if the image was inverted using the

^POI ZPL II command.

To change the value shown:

1. Press SELECT to select the parameter.

2. Press PLUS (+) or MINUS (-) to change the value shown.

3. Press

SELECT to accept any changes and deselect the parameter.

Table 12 • Printer Parameters (Page 5 of 24)

Parameter

Action/Explanation

Table 13 • Print Width Ranges and Maximum Values

Printhead

Resolution

Printer

ZM400 ZM600

200 dpi

Default Value: 832

Range: 2 to 832 dots

Default Value: 1344

Range: 2 to 1344 dots

300 dpi

Default Value: 1248

Range: 2 to 1248 dots

Default Value: 1984

Range: 2 to 1984 dots

600 dpi

Default Value: 2496

Range: 2 to 2496 dots

N/A

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 145 146

No comments

Zebra S400 User's Guide Page 74