Zebra 105SL User Manual download pdf (Page 48)

24 105SL User Guide 6/4/2004 11342L Rev. 8

Printer Operation

Roll Media Loading

Rewind Mode

Refer to Figure 17. The following instructions pertain to printers with the Rewind option only.

To load media in Rewind mode, complete these steps:

1. Remove the rewind plate from its storage location in front of the print mechani s m in side

the media compartment.

2. Invert the rewind plat e so that the lip on the attached hook plate points down.

3. Insert the hook plate lip a short distance (0.5 in. or 13 mm) into the lower opening in the

side plate.

4. Align the upper end of the rewind plate with the corresponding opening in the side plate.

Slide in the rewind plate so that it stops against the printer’s main frame.

5. Open the p r i nthead.

6. Slide the media guide and media supply guide as far from the printer frame as possible.

7. Load media as shown.

8. When loading media, al low approximatel y 36 in. (915 mm) of media to extend past the

printhead. Remove all labels from this portion to create a leader.

9. Remove the ho ok from the rewind spin dle. If you ar e using a core, slid e it on to the rewin d

spindle until it is flush against the guide plate.

10. Wind the label liner around either the 3 in. (76.2 mm) core or the rewind spindle and

reinstall the hook.

11. Slide in the media guide and media supply guide so they just to uch, but do not restrict, the

edge of the roll.

12. Close the printhea d .

Note • Before closing the printhead, make sur e:

• The media is positioned against the inside guides.

• The media is taut an d para llel wi th itsel f and th e pa thwa y when woun d onto the rewin d

spindle or co re.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 129 130

No comments

Zebra 105SL User Manual Page 48