Zebra QLn420 User's Guide download pdf (Page 18)

QLn Series User Guide

Model UCLI72-4 Quad Charger (All QLn Series Printers)

The UCLI72-4 Quad Charger is designed to charge up to

four QLn battery packs simultaneously. Batteries must be re-

moved from the printer to be charged in the Quad Charger.

1. Ensure that the charger has been installed properly per

the Quad Charger instruction manual. Ensure that the

power indicator on the front panel is on.

2. Remove any protective shrink-wrap and labels from all

battery packs prior to use. Plug a battery pack into any one

of the four charging bays as shown in Figure 6, noting the

orientation of the battery pack. Slide the battery pack into

the charging bay until it stops and then rock the battery

pack back until it snaps into place. The amber indicator di-

rectly under the battery being charged will turn on if the

battery is properly inserted.

The indicators under the battery will allow you to monitor

the charging process per the table below:

Amber Green Battery Status

On Off Charging

On Flashing

80% charged (O.K.

to use)

Off On

Completely

Charged

Flashing Off Fault

Important • A fault condition is caused by a problem with the battery.

The charger may indicate a fault because the battery is too hot or

cold to charge reliably. Try to charge the battery again when it returns

to the room’s ambient temperature. If the amber indicator starts

ashing on the second attempt, the battery should be discarded.

Always dispose of batteries in a proper manner as described in

Appendix F.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 102 103

No comments

Zebra QLn420 User's Guide Page 18