50 ZebraNet 10/100 Print Server User and Reference Guide
Installation
External 10/100 PS
This illustration calls out the location and provides an enlarged illustration of the
parallel port:
6 Secure the wire locks.
7 On the back of the 10⁄100 PS, connect an active ethernet cable to the RJ-45
connector Ethernet connector.
8 Turn on (I) the printer.
The 10⁄100 PS performs a Power On Self Test (POST). This takes about 45
seconds. During the POST, the 10⁄100 PS Status LED (just below the TEST
button) turns red and flashes on and off. Once the POST is successfully completed
and the 10⁄100 PS is fully initialized, the 10⁄100 PS Status LED turns green.
For more details on status indicators, see 10/100 PS Status Indicator on page 124.
9 To check the status of the 10⁄100 PS, press the Test button located on the back of
the 10⁄100 PS.
The prints out a configuration label of the 10⁄100 PS.
Note • If there is not an active Ethernet cable attached to the 10⁄100 PS, the LED
indicator turns green and rapidly flashes on and off.
3DUDOOHO
&RQQHFWRU
3ULQWHU%DFN
Comments to this Manuals