Page Setup
FF (Form Feed)
102
P1003640-002 TTP 2100 Technical Manual 09/28/2009
FF (Form Feed)
Use FF to print the buffer content, go to the next top of form (black-mark), and cut the paper.
ESC Z (Go To Next Top of Form)
Use ESC Z to move the paper to the next top of form. This is practically a Form-Feed without
printing and cut. It searches for the next black-mark for maximum one page length + black-
mark length (256 x n37 + n38 + n39)/8. An additional length of 20 mm is added to be sure to
pass the edge of the next black-mark. If there is no black-mark within the set distance plus
20 mm, an error is raised.
The commands are used together in the following way:
Black-Mark Sensing from within Windows
Refer to the Driver Reference Guide, Part Number P1006873-001, available for download
from http://www.zebra.com for detailed information on Black-Mark Sensing.
Example • The following examples are not made for a specific programming language or
editor, but can be implemented with the tools of your choice. The data sent to the printer are
marked with “Send→”.
When setting up the printer:
Send→ <ESC>& P<35><1> Enables black-mark sync
Cut Offset parameters n41 and n42.
Send→
<ESC>&<4> Stores the above parameters as default parameters.
The above sets up and stores the parameters in the EEPROM of the printer, so this needs only
be sent once to the printer when setting it up for TOF-mark sync.
Document:
Send→ the text and graphics
At the end of the document:
Send→ ESC Z Feeds the printout to the next black-mark + the additional feed specified by
the Cut Offset parameters n41 and n42 command.
Send→ RS Cuts and ejects the printout.
Comments to this Manuals