Zebra Printer 8 User Manual download pdf (Page 219)

P1045430-002 Zebra ZXP Series 8 Card Printer User’s Manual 215

Appendix H

Packing the Printer with

Laminator for Shipment

Introduction

If the printer is to be shipped, it is important to use the original packing and shipping

material to prevent damage to the Printer.

If the original material is lost, a replacement Shipping Kit can be ordered from Zebra; see

the Spare Part Kits listing in the Service Manual, or check the Partner Zone at

www.zebra.com.

Procedure

Step 1. Remove any cards from the Input and Output Hoppers.

Step 2. If the unit still has power applied and is turned on and is still connected to the

host computer, set the unit’s power switch (on the back of the printer part of the unit)

to the OFF ( ) position; and disconnect the interface and power cables.

Step 3. Open the printer door, and remove the print ribbon and transfer film. If you wish to

save the print ribbon and transfer film for future use, we suggest you place them in

sealable plastic bags for storage so they do not dry out or get dirty.

Step 4. Remove the cleaning cartridge and cleaning roller, and place them in the cutouts in

the lower foam insert.

Note • The specifics of the shipment and the printer’s condition may influence which of the

following steps are followed; common sense should prevail.

1 2 ... 214 215 216 217 218 219 220 221 222 223 224 225 226

No comments

Zebra Printer 8 User Manual Page 219