Zebra TTPM2 Specifications download pdf (Page 33)

03/05/2009 TTPM2™ Installation and Programming Manual P1003645-001

Command Reference

System Related Commands

This command takes no parameter. All definitions are cleared. Stored layout is erased.

Subsequent !C’s are ignored.

The !C command is also used to initialize TTPM2 after a power ON. If existing print layout

shall be saved, !P shall be used for printer initialization. See TTPM2 Start-Up on page 59.

If no fixed data is used on the tickets, Autoclear can be used to clear the memory between

tickets instead of using !C. Autoclear executes faster than !C. When autoclear is enabled any

!C commands in the received data will be ignored, apart from when initiating the printer.

Setting DIP-switch 4 to ON enables Autoclear.

• !CA, adding an A to the !C command enables extended acknowledgement.

• !C1, adding the digit 1 to the !C command clears the wastebasket counter. See !Y1.

This command effects both the encoding, printing, cutting and ejecting of a ticket.

Printing follows a successful encoding. The magnetic code and print information, as well as

cut and eject behavior, must first be defined using the applicable commands.

The Print command can also be used to initialize the TTPM2 after power OFF (as an

alternative to !C) in order to save any ticket layout stored in the TTPM2. See Additional

Commands on page 29 and TTPM2 Start-Up on page 59.

If !P is received and the printer is out of paper, it will give error code NAK P and discard the

received data.

!C Clear all

!P Print

3. Introduced in firmware in version 4.13

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 101 102

No comments

Zebra TTPM2 Specifications Page 33