Zebra CPCL Specifications download pdf (Page 57)

Device Manager

KR403 Specific User Interface

06/13/2011 ZPL & CPCL Printer Driver for OPOS Application Programmer’s Guide P1014152-002 Rev. A

Variable Continuous Mode 2

Implementation

To begin printing in variable continuous mode, we need to issue PrintNormal statements until

the minimum page length is exceeded and the cut command is received.

This means we have to establish a hybrid. Using page mode and continuous mode, you will set

up a requirement to cut at any location (other the end of the page), once the minimum page

length is exceeded.

When using variable mode, you need to also set a minimum page length in order to accomplish

the desired effect. In this mode, the printer is feeding paper without length limitation (besides

the minimum presenter length).

Example • Variable Continuous Mode 2:

• You have a set label width

• You have a minimum label height of 70 mm

• You have a Label Home (left and top)

You print content that is exceeding the minimum page and you receive a cut command.

The

printer shall not feed to the end of the page and cut right after the last print.

In this example, only the minimum page length is honored and after the minimum length is

exceeded the printer can cut at any location after the last print statement.

Note • This requirement is introduced due to a change in the original firmware behavior to

the new minimum page length requirement.

Note • Variable mode is the default mode for the KR403.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 69 70

No comments

Zebra CPCL Specifications Page 57