Summary of Firmware Release
V68.19.2Z
2
P1040502-015 05/09/2013
Changes
• The QLn420 battery eliminator is now supported.
• Additional 802.11n country codes supported – Israel, Argentina, Chile, and Honduras.
• This release includes support for simultaneous 802.11 a/b/g/n and Bluetooth Dual Radio.
Issues Corrected
• Peel sensor performance has been corrected to support additional use cases
• Enhanced memory management to resolve text field not printing issue.
• To support applications created for the QLPlus, if the printer is in CPCL synchronous
mode with “on out of paper” set to PURGE and Retry set to “1”, the printer will discard
the current label when the printer runs out of paper or the head is opened.
V68.19.2Z
Release Date: 15 February 2012
This firmware is for use with the following printer models:
• QLn220
• QLn320
• QLn420
This firmware includes all features of the previous V68.19.1Z and V68.18.8Z.
Issues Corrected
• Printer will no longer skip labels when ^LT and ^PQ are used in a format.
Note • The Dual radio option is only available on the n radio configuration. By default, the
Bluetooth radio is disabled on printers that support dual radio. The Bluetooth radio can be
enabled by using the bluetooth.enable command. When both the WLAN and
Bluetooth radios are enabled, the wlan.power_save feature will be turned off.
Note • When updating from firmware V68.16.3Z or any earlier version, users must first
update the printer to V68.18.6Z, before updating to any later versions. We also recommend
that users power cycle the printer after the update to V68.18.6Z, before moving to any later
versions.
In addition, when updating from firmware V68.18.1Z or any earlier version, we
recommend users
default the printer after updating to a later firmware version. To default the
printer, send these ZPL commands to the unit:
^XA^JUF^XZ
^XA^JUS^XZ
Wait 5 seconds after sending these command and then power cycle the printer.
Comments to this Manuals