Zebra QLn420 User Manual download pdf (Page 17)

Summary of Firmware Release

V68.16.3Z

05/09/2013 P1040502-015

Using Anonymous FTP Login from a Microsoft Windows Platform

A new SGD parameter (ip.ftp.request_password) has been added to control whether the

password was requested by the ftp client. In order to make the QLn behave the same way as

the legacy QL Plus family did when sending an ftp –A command from a Microsoft Windows

platform, first send the following command to the printer:

Note that the default behavior for QLn is similar to Zebra desktop and tabletop printers (i.e.,

the default value for the above SGD is “no”).

V68.16.3Z

Release Date: 6 September 2011

Enhancements

• 802.11: Added wlan.roam.interval parameter, reduces roaming

• 802.11: Improved roaming algorithm

Issues Corrected

• HW: Incorrect media width sensor operation

• HW: Enable charging circuit on power up

• COMM: Serial and USB port lockup after 1020 labels on QLn220 only

• CPCL: QLn responding incorrectly in CPCL synchronous mode

• CPCL: After media load PRESENT-AT is not performed

• CPCL: Print redirection not working when run from a startup file

• Ethernet: DHCP fails on soft reset when docked

• 802.11: Application corruption when mirroring

• 802.11: WEP-128 requires all four keys to be set, should only need one

• 802.11: IP roam packets not sent if WEP-128 is used

• 802.11: Roaming thresholds using incorrect values, see note below

• 802.11: Updated roaming related default values, see note below

• 802.11: “Loss of Signal” alert messages are too aggressive

• 802.11: In range roaming based on signal strength does not work

• WML: Unable to display full Latin character set using custom WML files

! U1 setvar "ip.ftp.request_password" "yes"

1 2 ... 12 13 14 15 16 17 18 19 20

No comments

Zebra QLn420 User Manual Page 17