Zebra 170PAX2 Series User's Guide download pdf (Page 24)

The default password value is 1234. The password can be changed using the ^KP

(Define Password) ZPL II instruction.

NOTE: Once the password has been entered correctly, it will not have to be entered

again unless you leave and re-enter the programming mode using the SETUP/EXIT

key.

NOTE: You can disable the password protection feature so that it no longer prompts

you for a password by setting the password to ØØØØ via the ^KPØ ZPL/ZPL II

command. To re-enable the password-protection feature, send the ZPL/ZPL II com-

mand ^KPx, where “x” can be any number, one to four digits in length,

except Ø.

Leaving the Setup Mode

You can leave the program mode at any time by pressing the SETUP/EXIT key. The

“SAVE CHANGES” display will appear. There are five choices, described below.

Pressing the LEFT or RIGHT BLACK OVAL key displays other choices and pressing

the NEXT/SAVE key selects the displayed choice.

• PERMANENT - Permanently saves the changes. Values are stored in the print

engine even when power is turned off.

• TEMPORARY - Saves the changes until changed again or until power is turned

off.

• CANCEL - Cancels all changes since pressing the SETUP/EXIT key except the

darkness and tear-off settings (if they were changed).

• LOAD DEFAULTS - Loads factory defaults. The factory defaults are shown on

the following pages.

NOTE: Loading factory defaults will require print engine calibration.

• LOAD LAST SAVE - Loads values from the last permanent save.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 99 100

No comments

Zebra 170PAX2 Series User's Guide Page 24