Zebra 170PAX2 Series User Manual download pdf (Page 5)

05/25/2005 1 47867L-001 Rev. A

Front Panel Programming

X.9.x firmware has added new parameters to the Front Panel Configuration (XiII series printer

and 170PA X /170PA X 2 series print engine only). X.10.x firmware has these same parameters

for the XiIII series and PA X3 series printers. X.13.x firmware has these same parameters for

the XiIIIPlus series and PA X 4 series printers.These parameters are located immediately

following the LCD ADJUST prompt. (Refer to the printer/print engine User Guide for

complete configuration information.)

Real Time Clock Parameters

The parameters listed on the following pages are added to the Front Panel Configuration

prompts only when both the Real Time Clock hardware option and the following versions of

firmware are installed:

• X.9.x or above firmware installed in the XiII series printers or the 170PAX /170PA X 2 series

print engines.

• X.10.x or above firmware installed in the XiIII series printers or the PA X 3 series print

engines.

• X.13.x or above firmware installed in the XiIIIPlus series printers or the PA X4 series print

engines.

The RTC ZPL II Commands apply to all printers/print engines with the Real Time Clock

hardware option and proper firmware (see Document Scope on page iv for printers/print

engines and firmware versions).

1 2 3 4 5 6 7 8 9 10 ... 19 20

No comments

Zebra 170PAX2 Series User Manual Page 5