Zebra A300 User's Guide download pdf (Page 28)

9600 baud, 8 bit word length, no parity, and 1 stop bit. Then, set the

communications parameters on your computer to match this.

• If you need to use different settings than the defaults (for example, if

you are using a modem with certain requirements), you have two

options for setting the communications parameters. Send the ^SC “Set

Communications” ZPL II command (described below) at 9600 baud via

the serial port set up as shown above, then reset the computer to the new

values. Or, send the ^SC command via the parallel port, then reconnect

for serial port operation as needed. To save these settings permanently,

send the ^JUs ZPL II command or re-calibrate the printer. See “Calibra-

tion” on page 18. Here is the command description for the Set Commu-

nications command (refer to your ZPL II Programming Guide for

additional programming information):

^SCa,b,c,d,e,f

where

a = baud rate (110 - 19200 baud)

b = word length (7 or 8 data bits)

c = parity (N = none, E = even, O = odd)

d = stop bits (1 or 2 )

e = handshake (X = XON/XOFF, D = DTR/DSR)

f = Zebra protocol (Y = yes, N = no)

If you do not specify a new setting for a parameter, it remains

unchanged (it does not change to the default value).

If you are using BAR-ONE or other software, adjust the relative darkness

setting as indicated in that software. Or, if you are using ZPL II, send the

^MD (Media Darkness) or ~SD (Set Darkness) ZPL II command.

You may choose to network your Zebra T300 printer. Contact your distribu-

tor for information about the ZebraNet micro print server—ethernet connec-

tivity for your Zebra T300 printer.

547000r1 Page 19 Tuesday, March 25, 1997 11:38 AM

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 37 38

No comments

Zebra A300 User's Guide Page 28