OC Command - Cutter Option Select
Description This sub-command is used to enable the cutter
option feature when installed. This
sub-command set of the O command works
with other O Option commands.
See the Command Reference, Section 2, and
the Advanced Programming, Appendix G, for
additional O (Option) command parameters.
Syntax OC[p
1
]
Enables the label liner cutter. The cutter
will cut at the end of each form as specified by
the Q command.
Some options are model specific. Refer to Options
Availability Table on page 40, for option command
availability for each printer model.
Parameters p
1
= Sets the number of labels to print prior to
cut.
If a number between 1 - 255 is specified
for p1, the printer will cut after the speci-
fied number of labels have been printed.
If b is specified for p
1
, the “batch print
& cut” feature is enabled. This feature
uses the P command to control cutter
operation.
(The p
1
command option is not sup
-
ported by the TLP2046 printer).
When using direct thermal media in a TLP series
printer, the proper option command to enable the
cutter is OD,C.
980009-001 Rev.E F-5
Appendix F - Cutter Option Programming
Comments to this Manuals