Zebra RW 420 User's Guide download pdf (Page 67)

RW Series User Guide

RW 420 Media Specications

Media Width 2.0 in. to 4.12 in.

(50.8 to 104.6 mm)

Max. continuous Continuous, dependent on installed memory

receipt (w/std. memory)

Inter-label Gap. 0.08 in. to 0.16 in. (0.12 in. preferred)

(2 mm to 4 mm [3 mm preferred])

Label Thickness .0025” to .0065” (.064 mm to .165 mm)

Max. Label Roll dia. 2.25 in. (57 mm) O.D.

Label Inner Core .75 in. (19 mm) minimum dia;

1.38 in. (35 mm) optional setting

Black Mark The reflective media black marks should

Dimensions extend past the centerline of the roll.

Media Minimum mark width: 1.0” (25.4 mm)

Requirements perpendicular to edge of media, centered within

the width of the roll.

Mark length: 0.094” (2.4 mm) parallel to edge of

media

RW 220 Media Specications

Media Width 1.0” in. to 2.37 in.

[25.4 to 60.1 mm]

Max. continuous Continuous, dependent on installed memory

receipt (w/std. memory)

Inter-label Gap. 0.08 in. to 0.16 in. (0.12 in. preferred)

(2 mm to 4 mm [3 mm preferred])

Label Thickness .0025” to .0065” (.064 mm to .165 mm)

Max. Label Roll dia. 2.25 in. [57 mm] O.D.

Label Inner Core .75 in. [19 mm) minimum dia;

1.38 in. (35 mm) optional setting

Black Mark The reflective media black marks should

Dimensions extend past the centerline of the roll.

Media Minimum mark width: .5” (12.7 mm)

Requirements perpendicular to edge of media, centered within

the width of the roll.

Mark length: 0.094” (2.4 mm) parallel to edge of

media

Use Zebra brand direct thermal media that is outside wound. Media may be reective (black mark) sensing,

or transmissive (gap) sensing, die-cut, or continuous. RW 420 units congured with the External Media

option will accept fanfold media used with an external media supply.

For die-cut labels, use only full auto dies.

continued

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 85 86

No comments

Zebra RW 420 User's Guide Page 67