Zebra DA402 User's Guide download pdf (Page 37)

Feed Button Modes

Power Off Mode (Communications Diagnostics Mode)

With the printer power off, press and hold the feed button while you turn on the

power.Theprinterprintsoutalistingofitscurrentconfiguration(seeFigure22).

After printing the label, the printer will automatically enter a diagnostic mode in

whichtheprinterprintsoutaliteralrepresentation(seeFigure23)ofalldata

subsequently received. To exit the diagnostic mode and resume printing, turn off

and then turn on the printer.

Power On Modes

With the printer power on and top cover closed, press and hold the feed button for

several seconds. The green status LED will flash a number of times in sequence.

The explanation at the right (Action) shows what happens when you release the key

after the specific number of flashes.

Flash

Sequence Action

* A configuration label prints.

The media sensor calibrates and a media sensor profile prints (see

“ManualCalibration”onpage28).

***

To reset the communication parameters: Press and release the feed

button while the LED rapidly flashes yellow and green. The serial

communication parameters reset to 9600 baud, 8 bits per character,

no parity, 1 stop bit, and XON/XOFF.

For autobaud synchronization: Send a ZPL II format to the printer

while the LED rapidly flashes yellow and green. When the printer and

host are synchronized, the LED changes to solid green. NOTE: No

labels will print during autobaud synchronization.

***

****

Resets the factory defaults, auto calibrates, and saves settings into

memory.

***

****

*****

The print width calibrates. While the status LED alternately flashes

green and yellow, a series of stacking rectangles print on the label.

When the rectangle prints to the outer edges of the label, press and

release the feed button. The label width and current communication

parameters will be saved into memory.

***

****

*****

******

The print darkness calibrates. A series of nine samples print, starting

with the lightest and ending with the darkest image. When the desired

print darkness is achieved, press and release the feed button. The

print darkness will be saved into memory.

If the feed button remains pressed after a 7-flash sequence, the printer will ignore

the button when it is released.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 55 56

Comments to this Manuals

No comments

Zebra DA402 User's Guide Page 37

Comments to this Manuals

Related products and manuals for Label printers Zebra DA402